Cecil E. Hall

Improved electron micrographs of the shadow-cast bovine fibrinogen molecule have been obtained establishing its general morphology and dimensions in the dry state. It consists of a linear array of 3 nodules held together by a very thin thread which is estimated to have a diameter of from 8 to 15 A, though it is not clearly resolved. The two end nodules are alike but the center one is slightly smaller. Measurements of shadow lengths indicate that nodule diameters are in the range 50 to 70 A. The length of the dried molecule is 475 +/- 25 A. Adopting the molecular volume from previous physical chemical data and the general morphological features and length from electron microscopy, we calculate the diameters of the end nodules to be 65 A and the center one as 50 A. The model of the molecule so obtained is consistent with the electron microscopical observations and the data from physical chemistry. The intermediate polymers formed when fibrinogen is activated with thrombin were also examined and found to be end-to-end aggregates of altered fibrinogen molecules which shrink in length during the process. Intermediate polymer lengths are from 1000 to 5000 A. The nodular nature of fibrinogen, its shrinkage and end-to-end aggregation on polymerization permits us to deduce an explanation for the system of cross-bands previously observed in stained fibrin fibrils.

Methods are described for determining the relative mass of particles in electron microscope specimens through the measurement of photographic densities in recorded images. These methods were applied to a quantitative study of the amounts of electron stains that could be associated with the particles of tomato bushy stunt virus (BSV) and tobacco mosaic virus (TMV). In the pH range above 2 where the viruses are stable, the amount of stain absorbed is too small to produce adequate contrast in the electron microscope. Maximum stain absorption was achieved at pH about 1 where with several reagents and combinations of reagents the mass of BSV could be increased to about four times that of the unstained particles. Optimum results were obtained with phosphotungstic acid alone or in combination with Pt, Th, or La ions. Since the pH conditions for high stain absorption are normally destructive, morphology is satisfactorily preserved only when the phosphotungstic acid is applied in concentrations of 10 per cent or greater or when the use of destructive reagents is preceded by a preliminary fixation under mild conditions. Maximum staining of TMV increased the mass of the particles to about two times that of the unstained. Estimates of the mass of heavily stained BSV particles indicate that their density is 3.3 gm./cm.(3) The high internal hydration of BSV probably accounts for the greater stain absorption and penetration compared to those of TMV which has very low or zero internal hydration. Anomalous images resulting from the use of electron stains are shown and discussed.

ADVERTISEMENT RETURN TO ISSUEPREVArticleNEXTA Comparison between the Dimensions of Some Macromolecules Determined by Electron Microscopy and by Physical Chemical MethodsCecil E. Hall and Paul DotyCite this: J. Am. Chem. Soc. 1958, 80, 6, 1269–1274Publication Date (Print):March 1, 1958Publication History Published online1 May 2002Published inissue 1 March 1958https://pubs.acs.org/doi/10.1021/ja01539a001https://doi.org/10.1021/ja01539a001research-articleACS PublicationsRequest reuse permissionsArticle Views121Altmetric-Citations131LEARN ABOUT THESE METRICSArticle Views are the COUNTER-compliant sum of full text article downloads since November 2008 (both PDF and HTML) across all institutions and individuals. These metrics are regularly updated to reflect usage leading up to the last few days.Citations are the number of other articles citing this article, calculated by Crossref and updated daily. Find more information about Crossref citation counts.The Altmetric Attention Score is a quantitative measure of the attention that a research article has received online. Clicking on the donut icon will load a page at altmetric.com with additional details about the score and the social media presence for the given article. Find more information on the Altmetric Attention Score and how the score is calculated. Share Add toView InAdd Full Text with ReferenceAdd Description ExportRISCitationCitation and abstractCitation and referencesMore Options Share onFacebookTwitterWechatLinked InRedditEmail Other access optionsGet e-Alertsclose Get e-Alerts