Paul Venema

The proteinaceous material present in beta-lactoglobulin fibrils formed after heating (20 h at 85 degrees C) at pH 2 was identified during this study. Fibrils were separated from the nonaggregated material, and the fibrils were dissociated using 8 M guanidine chloride and 0.1 M 1,4-dithiothreitol (pH 8). Characterization of the different fractions was performed using thioflavin T fluorescence, high-performance size-exclusion chromatography, reversed-phase HPLC, and mass spectrometry (MALDI-TOF). Beta-lactoglobulin was found to be hydrolyzed into peptides with molecular masses between 2000 and 8000 Da, and the fibrils were composed of a part of these peptides and not intact beta-lactoglobulin. The majority of the peptides (both aggregated and nonaggregated) were a result from cleavage of the peptide bonds before or after aspartic acid residues. Explanations for the presence of certain peptide fragments in the fibrils are the hydrophobicity, low charge, charge distribution, and capacity to form beta-sheets.

Long, fibrillar semiflexible aggregates were formed from soy glycinin and soy protein isolate (SPI) when heated at 85 degrees C and pH 2. Transmission electron microscopy analysis showed that the contour length of the fibrils was approximately 1 microm, the persistence length 2.3 microm, and the thickness a few nanometers. Fibrils formed from SPI were more branched than the fibrils of soy glycinin. Binding of the fluorescent dye Thioflavin T to the fibrils showed that beta-sheets were present in the fibrils. The presence of the fibrils resulted in an increase in viscosity and shear thinning behavior. Flow-induced birefringence measurements showed that the behavior of the fibrils under flow can be described by scaling relations derived for rodlike macromolecules. The fibril formation could be influenced by the protein concentration and heating time. Most properties of soy glycinin fibrils are comparable to beta-lactoglobulin fibrils.

The effect of stirring and seeding on the formation of fibrils in whey protein isolate (WPI) solutions was studied. More fibrils of a similar length are formed when WPI is stirred during heating at pH 2 and 80 degrees C compared to samples that were heated at rest. Addition of seeds did not show an additional effect compared to samples that were stirred. We propose a model for fibril formation, including an activation, nucleation, growth, and termination step. The activation and nucleation steps are the rate-determining steps. Fibril growth is relatively fast but terminates after prolonged heating. Two processes that possibly induce termination of fibril growth are hydrolysis of nonassembled monomers and inactivation of the growth ends of the fibrils. Stirring may break up immature fibrils, thus producing more active fibrils. Stirring also seems to accelerate the kinetics of fibril formation, resulting in an increase of the number of fibrils formed.