Cited by 107
University of Science and Technology Beijing
ORCID: 0000-0003-1866-5759Publishes on Rock Mechanics and Modeling, Tailings Management and Properties, Concrete and Cement Materials Research. 28 papers and 872 citations.
Add your photo, update your bio, and get notified when your ranking changes.
Understanding the flow process of cemented tailings backfill (CTB) is important for successful pumping into underground stopes. This study examines the effects of solid content (SC), cement/tailings (c/t) ratio, and curing time (CT) on rheological and mechanical properties of CTB mixes. The slurry concentration of the mixes was 65, 67, and 69 wt. %, with c/t ratios ranging from 1:4 to 1:20. Unconfined compressive strength (UCS) tests were performed on hardened CTB mixes after curing 3, 7, and 28 days. The rheological properties of CTB slurries are mainly related to SC. The yield stress and viscosity of fresh mixes increase with increasing SC, but the pipeline resistance loss (PRL) also increases with increasing SC. According to the analysis of variance, the SC and flow rate are the most significant parameters which greatly affect the PRL performance. The c/t and CT parameters are the most significant parameters for affecting the shrinkage rate. The findings offer a reference for theoretical optimization for mine filling systems of similar type.
Using solid wastes (SWs) as backfilling material to fill underground mined-out areas (UMOAs) solved the environmental problems caused by SWs and reduced the backfilling cost. In this study, fly ash (FA), gypsum and steel slag (SS) were used to prepare cement-based composites (CBC). The uniaxial compression, computed tomography (CT) and scanning electron microscope (SEM) laboratory experiments were conducted to explore the macro and micromechanical properties of CBC. The findings showed that the uniaxial compressive strength (UCS) of CBC with a curing time of 7 d could reach 6.54 MPa. The increase of SS content reduced the UCS of CBC, while the gypsum and FA content could increase the UCS of CBC. Microscopic studies have shown that the SS particles in CBC have noticeable sedimentation, and the increase of SS content causes the failure mode of CBC from tensile to tensile-shear. These research results can provide a scientific reference for the preparation of backfilling materials.