Chwee Teck Lim

Humans rely increasingly on sensors to address grand challenges and to improve quality of life in the era of digitalization and big data. For ubiquitous sensing, flexible sensors are developed to overcome the limitations of conventional rigid counterparts. Despite rapid advancement in bench-side research over the last decade, the market adoption of flexible sensors remains limited. To ease and to expedite their deployment, here, we identify bottlenecks hindering the maturation of flexible sensors and propose promising solutions. We first analyze challenges in achieving satisfactory sensing performance for real-world applications and then summarize issues in compatible sensor-biology interfaces, followed by brief discussions on powering and connecting sensor networks. Issues en route to commercialization and for sustainable growth of the sector are also analyzed, highlighting environmental concerns and emphasizing nontechnical issues such as business, regulatory, and ethical considerations. Additionally, we look at future intelligent flexible sensors. In proposing a comprehensive roadmap, we hope to steer research efforts towards common goals and to guide coordinated development strategies from disparate communities. Through such collaborative efforts, scientific breakthroughs can be made sooner and capitalized for the betterment of humanity.

In this article, ultrafine gelatin (Gt) fibers were successfully produced with the use of the electrical spinning or electrospinning technique. A fluorinated alcohol of 2,2,2-trifluoroethanol (TFE) was used as the dissolving solvent. The morphology of the electrospun gelatin fibers was found to be dependent on the alteration of gelatin concentration ranging from 2.5% w/v to 12.5% w/v at 2.5% increment intervals. Based on the electrospun gelatin fibers obtained, 10% w/v gelatin/TFE solution was selected and mixed with 10% w/v poly(epsilon-caprolactone) (PCL) in TFE at a ratio of 50:50 and co-electrospun to produce gelatin/PCL composite membranes. Contact-angle measurement and tensile tests indicated that the gelatin/PCL complex fibrous membrane exhibited improved mechanical properties as well as more favorable wettability than that obtained from either gelatin or PCL alone. The gelatin/PCL fibrous membranes were further investigated as a promising scaffold for bone-marrow stromal cell (BMSC) culture. Scanning electron microscopy (SEM) and laser confocal microscopy observations showed that the cells could not only favorably attach and grow well on the surface of these scaffolds, but were also able to migrate inside the scaffold up to 114 microm within 1 week of culture. These results suggest the potential of using composite gelatin/PCL fibrous scaffolds for engineering three-dimensional tissues.

Abstract Nanoflakes of α‐Fe 2 O 3 were prepared on Cu foil by using a thermal treatment method. The nanoflakes were characterized by X‐ray diffraction, scanning electron microscopy, high‐resolution transmission electron microscopy, and Raman spectroscopy. The reversible Li‐cycling properties of the α‐Fe 2 O 3 nanoflakes have been evaluated by cyclic voltammery, galvanostatic discharge–charge cycling, and impedance spectral measurements on cells with Li metal as the counter and reference electrodes, at ambient temperature. Results show that Fe 2 O 3 nanoflakes exhibit a stable capacity of (680 ± 20) mA h g –1 , corresponding to (4.05 ± 0.05) moles of Li per mole of Fe 2 O 3 with no noticeable capacity fading up to 80 cycles when cycled in the voltage range 0.005–3.0 V at 65 mA g –1 (0.1 C rate), and with a coulombic efficiency of > 98 % during cycling (after the 15th cycle). The average discharge and charge voltages are 1.2 and 2.1 V, respectively. The observed cyclic voltammograms and impedance spectra have been analyzed and interpreted in terms of the ‘conversion reaction' involving nanophase Fe 0 –Li 2 O. The superior performance of Fe 2 O 3 nanoflakes is clearly established by a comparison of the results with those for Fe 2 O 3 nanoparticles and nanotubes reported in the literature.

The culture of bone marrow derived mesenchymal stem cells (MSCs), as well as the control of its differentiation toward different tissue lineage, is a very important part of tissue engineering, where cells are combined with artificial scaffold to regenerate tissues. Graphene (G) and graphene oxide (GO) sheets are soft membranes with high in-plane stiffness and can potentially serve as a biocompatible, transferable, and implantable platform for stem cell culture. While the healthy proliferation of stem cells on various carbon platforms has been demonstrated, the chemical role of G and GO, if any, in guiding uncommitted stem cells toward differentiated cells is not known. Herein, we report that the strong noncovalent binding abilities of G allow it to act as a preconcentration platform for osteogenic inducers, which accelerate MSCs growing on it toward the osteogenic lineage. The molecular origin of accelerated differentation is investigated by studying the binding abilities of G and GO toward different growth agents. Interestingly, differentiation to adipocytes is greatly suppressed on G because insulin, which is a key regulator for the synthesis of fatty acids, is denatured upon π-π adsorption on G; in contrast, GO does not interfere with adipogenesis due to electrostatic binding with insulin. The different binding interactions and their subsequent influence on stem cell growth and differentiation are ascribed to different degrees of π-π stacking and electrostatic and hydrogen bonding mediated by G and GO.