Fracture Propagation to the Base of the Greenland Ice Sheet During Supraglacial Lake DrainageSurface meltwater that reaches the base of an ice sheet creates a mechanism for the rapid response of ice flow to climate change. The process whereby such a pathway is created through thick, cold ice has not, however, been previously observed. We describe the rapid (<2 hours) drainage of a large supraglacial lake down 980 meters through to the bed of the Greenland Ice Sheet initiated by water-driven fracture propagation evolving into moulin flow. Drainage coincided with increased seismicity, transient acceleration, ice-sheet uplift, and horizontal displacement. Subsidence and deceleration occurred over the subsequent 24 hours. The short-lived dynamic response suggests that an efficient drainage system dispersed the meltwater subglacially. The integrated effect of multiple lake drainages could explain the observed net regional summer ice speedup.
Methane Hydrate and Free Gas on the Blake Ridge from Vertical Seismic ProfilingSeismic velocities measured in three drill holes through a gas hydrate deposit on the Blake Ridge, offshore South Carolina, indicate that substantial free gas exists to at least 250 meters beneath the bottom-simulating reflection (BSR). Both methane hydrate and free gas exist even where a clear BSR is absent. The low reflectance, or blanking, above the BSR is caused by lithologic homogeneity of the sediments rather than by hydrate cementation. The average methane hydrate saturation above the BSR is relatively low (5 to 7 percent of porosity), which suggests that earlier global estimates of methane in hydrates may be too high by as much as a factor of 3.
Variation in styles of rifting in the Gulf of CaliforniaStructure and composition of the Aleutian island arc and implications for continental crustal growthWe present results of a seismic reflection and refraction investigation of the Aleutian island arc, designed to test the hypothesis that volcanic arcs constitute the building blocks of continental crust. The Aleutian arc has the requisite thickness (30 km) to build continental crust, but it differs strongly from continental crust in its composition and reflectivity structure. Seismic velocities and the compositions of erupted lavas suggest that the Aleutian crust has a mafic bulk composition, in contrast to the andesitic bulk composition of continents. The silicic upper crust and reflective lower crust that are characteristic of continental crust are conspicuously lacking in the Aleutian intraoceanic arc. Therefore, if island arcs form a significant source of continental crust, the bulk properties of arc crust must be substantially modified during or after accretion to a continental margin. The pervasive deformation, intracrustal melting, and delamination of mafic to ultramafic residuum necessary to transform arc crust into mature continental crust probably occur during arc-continent collision or through subsequent establishment of a continental arc. The volume of crust created along the arc exceeds that estimated by previous workers by about a factor of two.
Mantle thermal structure and active upwelling during continental breakup in the North AtlanticW. Steven Holbrook, H. C. Larsen, Jun Korenaga et al.|Earth and Planetary Science Letters|2001