Christopher Wilson

A fundamental tenet of scientific research is that published results are open to independent validation and refutation. Minimum data standards aid data providers, users, and publishers by providing a specification of what is required to unambiguously interpret experimental findings. Here, we present the Minimum Information about a Flow Cytometry Experiment (MIFlowCyt) standard, stating the minimum information required to report flow cytometry (FCM) experiments. We brought together a cross-disciplinary international collaborative group of bioinformaticians, computational statisticians, software developers, instrument manufacturers, and clinical and basic research scientists to develop the standard. The standard was subsequently vetted by the International Society for Advancement of Cytometry (ISAC) Data Standards Task Force, Standards Committee, membership, and Council. The MIFlowCyt standard includes recommendations about descriptions of the specimens and reagents included in the FCM experiment, the configuration of the instrument used to perform the assays, and the data processing approaches used to interpret the primary output data. MIFlowCyt has been adopted as a standard by ISAC, representing the FCM scientific community including scientists as well as software and hardware manufacturers. Adoptionof MIFlowCyt by the scientific and publishing communities will facilitate third-party understanding and reuse of FCM data.

Abstract Granulite facies metapelites of the Mather and Filla Paragneisses within the Rauer Group, east Antarctica, possess markedly different compositions. The metamorphic evolution of the two metapelite types has been interpreted as temporally distinct, with the Rauer Group preserving at least two distinct granulite facies tectonothermal episodes. Calculated P–T pseudosections and orthopyroxene Al content indicate the revised maximum‐preserved P–T conditions within the Mather Paragneiss to lie in the vicinity of 950–975 °C and 10–10.6 kbar, less extreme than previous estimates. The range of possible P–T paths for the Mather Paragneiss consistent with mineral textural relationships and pseudosections contoured for mineral proportion are significantly shallower (d P /d T ) than previous estimates. A near‐isothermal decompression P–T path, and extreme peak metamorphic conditions, are not necessary to explain the development of preserved mineral reaction textures. The Filla Paragneiss contains pelitic assemblages less amenable to rigorous quantitative analysis. Nevertheless, possibilities for the shared or otherwise metamorphic evolution of the Mather and Filla Paragneisses may be postulated on the basis of calculated pseudosections in the context of existing geochronology for the Rauer Group and preserved microstructures. A shared evolution, most likely during Pan‐African granulite facies metamorphism, is plausible and consistent with mineral assemblage development, geochronology and microstructures. A revised interpretation of the Rauer Group's preserved metamorphic evolution may warrant the revision of existing tectonic models, applicable also to the remainder of Prydz Bay. More generally, the employed approach may incite a revision of peak P–T and P–T paths in other granulite facies terranes.

Reliability challenges of candidate metal systems to replace traditional Cu wiring in future interconnects are discussed. From a reliability perspective, a key opportunity is electromigration improvement: due to their high melting point and slower self-diffusion kinetics, higher current carrying capabilities are possible. Also, the higher cohesive energy and better resistance to oxidation of some metals potentially allows for barrierless integration, although adhesion properties must be carefully optimized. Besides avoiding small grain pinning and enabling high aspect ratio trench fill, the main processing challenges are identified to be a) avoiding seam voids, b) adhesion, c) CMP and d) disruptive metal etch. Main reliability challenges are related to higher mechanical stresses and higher joule heating which could lead to delamination during further processing and packaging and to enhanced electromigration in nearby metal lines.