Bhupinder Pal Singh

Biochar properties can be significantly influenced by feedstock source and pyrolysis conditions; this warrants detailed characterisation of biochars for their application to improve soil fertility and sequester carbon. We characterised 11 biochars, made from 5 feedstocks [Eucalyptus saligna wood (at 400°C and 550°C both with and without steam activation); E. saligna leaves (at 400°C and 550°C with activation); papermill sludge (at 550°C with activation); poultry litter and cow manure (each at 400°C without activation and at 550°C with activation)] using standard or modified soil chemical procedures. Biochar pH values varied from near neutral to highly alkaline. In general, wood biochars had higher total C, lower ash content, lower total N, P, K, S, Ca, Mg, Al, Na, and Cu contents, and lower potential cation exchange capacity (CEC) and exchangeable cations than the manure-based biochars, and the leaf biochars were generally in-between. Papermill sludge biochar had the highest total and exchangeable Ca, CaCO3 equivalence, total Cu, and potential CEC, and the lowest total and exchangeable K. Water-soluble salts were higher in the manure-based biochars, followed by leaf, papermill sludge, and wood biochars. Total As, Cd, Pb, and polycyclic aromatic hydrocarbons in the biochars were either very low or below detection limits. In general, increase in pyrolysis temperature increased the ash content, pH, and surface basicity and decreased surface acidity. The activation treatment had a little effect on most of the biochar properties. X-ray diffraction analysis showed the presence of whewellite in E. saligna biochars produced at 400°C, and the whewellite was converted to calcite in biochars formed at 550°C. Papermill sludge biochar contained the largest amount of calcite. Water-soluble salts and calcite interfered with surface charge measurements and should be removed before the surface charge measurements of biochar. The biochars used in the study ranged from C-rich to nutrient-rich to lime-rich soil amendment, and these properties could be optimised through feedstock formulation and pyrolysis temperature for tailored soil application.

The influence of biochar on nitrogen (N) transformation processes in soil is not fully understood. This study assessed the influence of four biochars (wood and poultry manure biochars synthesized at 400 degrees C, nonactivated, and at 550 degrees C, activated, abbreviated as: W400, PM400, W550, PM550, respectively) on nitrous oxide (N2O) emission and N leaching from an Alfisol and a Vertisol. Repacked soil columns were subjected to three wetting-drying (W-D) cycles to achieve a range of water-filled pore space (WFPS) over a 5-mo period. During the first two W-D cycles, W400 and W550 had inconsistent effects on N2O emissions and the soils amended with PM400 produced higher N2O emissions relative to the control. The initially greater N2O emission from the PM400 soils was ascribed to its higher labile intrinsic N content than the other biochars. During the third W-D cycle, all biochar treatments consistently decreased N2O emissions, cumulatively by 14 to 73% from the Alfisol and by 23 to 52% from the Vertisol, relative to their controls. In the first leaching event, higher nitrate leaching occurred from the PM400-amended soils compared with the other treatments. In the second event, the leaching of ammonium was reduced by 55 to 93% from the W550- and PM550-Alfisol and Vertisol, and by 87 to 94% from the W400- and PM400-Vertisol only (cf. control). We propose that the increased effectiveness of biochars in reducing N2O emissions and ammonium leaching over time was due to increased sorption capacity of biochars through oxidative reactions on the biochar surfaces with ageing.

The stability of biochar carbon (C) is the major determinant of its value for long-term C sequestration in soil. A long-term (5 year) laboratory experiment was conducted under controlled conditions using 11 biochars made from five C3 biomass feedstocks (Eucalyptus saligna wood and leaves, papermill sludge, poultry litter, cow manure) at 400 and/or 550 °C. The biochars were incubated in a vertisol containing organic C from a predominantly C4-vegetation source, and total CO(2)-C and associated δ(13)C were periodically measured. Between 0.5% and 8.9% of the biochar C was mineralized over 5 years. The C in manure-based biochars mineralized faster than that in plant-based biochars, and C in 400 °C biochars mineralized faster than that in corresponding 550 °C biochars. The estimated mean residence time (MRT) of C in biochars varied between 90 and 1600 years. These are conservative estimates because they represent MRT of relatively labile and intermediate-stability biochar C components. Furthermore, biochar C MRT is likely to be higher under field conditions of lower moisture, lower temperatures or nutrient availability constraints. Strong relationships of biochar C stability with the initial proportion of nonaromatic C and degree of aromatic C condensation in biochar support the use of these properties to predict biochar C stability in soil.

Biochar is produced as a charred material with high surface area and abundant functional groups by pyrolysis, which refers to the process of thermochemical decomposition of organic material at elevated temperatures in the absence of oxygen. The carbon component in biochar is relatively stable, and, hence, biochar was originally proposed as a soil amendment to store carbon in the soil. Biochar has multifunctional values that include the use of it for the following purposes: soil amendment to improve soil health, nutrient and microbial carrier, immobilising agent for remediation of toxic metals and organic contaminants in soil and water, catalyst for industrial applications, porous material for mitigating greenhouse gas emissions and odorous compounds, and feed supplement to improve animal health and nutrient intake efficiency and, thus, productivity. This article provides for the first time an overview of the multifunctional values and unintended consequences of biochar applications.