Chih‐I Wu

We realized photovoltaic operation in large-scale MoS2 monolayers by the formation of a type-II heterojunction with p-Si. The MoS2 monolayer introduces a built-in electric field near the interface between MoS2 and p-Si to help photogenerated carrier separation. Such a heterojunction photovoltaic device achieves a power conversion efficiency of 5.23%, which is the highest efficiency among all monolayer transition-metal dichalcogenide-based solar cells. The demonstrated results of monolayer MoS2/Si-based solar cells hold the promise for integration of 2D materials with commercially available Si-based electronics in highly efficient devices.

We demonstrate the improvement of an indium tin oxide anode contact to an organic light emitting device via oxygen plasma treatment. Enhanced hole-injection efficiency improves dramatically the performance of single-layer doped-polymer devices: the drive voltage drops from >20 to <10 V, the external electroluminescence quantum efficiency (backside emission only) increases by a factor of 4 (from 0.28% to 1%), a much higher drive current can be applied to achieve a much higher brightness (maximum brightness ∼10,000 cd/m2 at 1000 mA/cm2), and the forward-to-reverse bias rectification ratio increases by orders of magnitude (from 102 to 106–107). The lifetime of the device is also enhanced by two orders of magnitude.

Monolayer molybdenum disulfide (MoS2) has become a promising building block in optoelectronics for its high photosensitivity. However, sulfur vacancies and other defects significantly affect the electrical and optoelectronic properties of monolayer MoS2 devices. Here, highly crystalline molybdenum diselenide (MoSe2) monolayers have been successfully synthesized by the chemical vapor deposition (CVD) method. Low-temperature photoluminescence comparison for MoS2 and MoSe2 monolayers reveals that the MoSe2 monolayer shows a much weaker bound exciton peak; hence, the phototransistor based on MoSe2 presents a much faster response time (<25 ms) than the corresponding 30 s for the CVD MoS2 monolayer at room temperature in ambient conditions. The images obtained from transmission electron microscopy indicate that the MoSe exhibits fewer defects than MoS2. This work provides the fundamental understanding for the differences in optoelectronic behaviors between MoSe2 and MoS2 and is useful for guiding future designs in 2D material-based optoelectronic devices.

Blue electrophosphorescence in organic light-emitting diodes (OLEDs) is enhanced by the use of 3,6-bis(triphenylsilyl)carbazole (see figure). This carbazole derivative with sterically bulky and large-gap triphenylsilyl groups is an electrochemically and morphologically stable efficient host material for blue electrophosphorescence. When utilized in OLEDs, high efficiencies of up to 16 %, 30.6 cd A–1, and 26.7 lm W–1 are achieved.