Ramin Rahmani

Despite extensive research into alternative methods, the internal combustion engine is expected to remain as the primary source of vehicular propulsion for the foreseeable future. There are still significant opportunities for improving fuel efficiency, thus directly reducing the harmful emissions. Consequently, mitigation of thermal and frictional losses has gradually become a priority. The piston-cylinder system accounts for the major share of all the losses as well as emissions. Therefore, the need for an integrated approach, particularly of a predictive nature is essential. This paper addresses this issue, particularly the role of cylinder liner temperature, which affects both thermal and frictional performance of the piston-cylinder system. The study focuses on the top compression ring whose critical sealing function makes it a major source of frictional power loss and a critical component in guarding against further blow-by of harmful gasses. Such an integrated approach has not hitherto been reported in literature. The study shows that the cylinder liner temperature is critical in mitigating power loss as well as reducing Hydrocarbon (HC) and Nitrogen Oxide (NOx) emissions from the compression ring – cylinder liner conjunction. The results imply the existence of an optimum range for liner working temperature, independent of engine speed (at least in the studied cases) to minimise frictional losses. Combined with the study of NOx and HC emissions, the control of liner temperature can help to mitigate frictional power loss and reduce emissions.

In this study we attempt to find the optimum geometrical parameters of square-shaped micro-dimples imposed on parallel flat bearing surfaces, which give the best tribological performance, including the load capacity and the friction coefficient. An analytical solution of the Reynolds equation for the surfaces involving numerous dimples is presented, then considering the variations of the number of dimples as well as the dimple length, and the height ratios for a constant dimpled length, it is used to get the optimum value of the parameters. It is shown that despite the variations of different studied geometrical parameters, it seems the optimum value of these parameters remains nearly constant.

Reciprocating and low-speed sliding contacts can experience increased friction because of solid boundary interactions. Use of surface texturing has been shown to mitigate undue boundary friction and improve energy efficiency. A combined numerical and experimental investigation is presented to ascertain the beneficial effect of pressure perturbation caused by micro-hydrodynamics of entrapped reservoirs of lubricant in cavities of textured forms as well as improved micro-wedge flow. The results show good agreement between numerical predictions and experimental measurements using a precision sliding rig with a floating bed-plate. Results show that the texture pattern and distribution can be optimised for given conditions, dependent on the intended application under laboratory conditions. The translation of the same into practical in-field applications must be carried out in conjunction with the cost of fabrication and perceived economic gain. This means that near optimal conditions may suffice for most application areas and in practice lesser benefits may accrue than that obtained under ideal laboratory conditions.