Wear behavior of FDM parts fabricated by composite material feed stock filament
Kamaljit Singh Boparai(Guru Nanak Dev University), Harwinder Singh(Guru Nanak Dev University), Rupinder Singh(National Institute of Technical Teachers Training and Research)
Cited by 49
Related Papers
Development of rapid tooling using fused deposition modeling: a review
|Rapid Prototyping Journal|2016|224
Continuous improvement philosophy – literature review and directions
|Benchmarking An International Journal|2015|216
Total productive maintenance (TPM) implementation practice
|International Journal of Lean Six Sigma|2014|111
Comparison of tribological behaviour for Nylon6-Al-Al<sub>2</sub>O<sub>3</sub>and ABS parts fabricated by fused deposition modelling
|Virtual and Physical Prototyping|2015|109
Impact of lean practices on organizational sustainability through green supply chain management – an empirical investigation
|International Journal of Lean Six Sigma|2020|95