Mohammadreza Karamad

Abstract Electrochemically converting nitrate, a widespread water pollutant, back to valuable ammonia is a green and delocalized route for ammonia synthesis, and can be an appealing and supplementary alternative to the Haber-Bosch process. However, as there are other nitrate reduction pathways present, selectively guiding the reaction pathway towards ammonia is currently challenged by the lack of efficient catalysts. Here we report a selective and active nitrate reduction to ammonia on Fe single atom catalyst, with a maximal ammonia Faradaic efficiency of ~ 75% and a yield rate of up to ~ 20,000 μg h −1 mg cat. −1 (0.46 mmol h −1 cm −2 ). Our Fe single atom catalyst can effectively prevent the N-N coupling step required for N 2 due to the lack of neighboring metal sites, promoting ammonia product selectivity. Density functional theory calculations reveal the reaction mechanisms and the potential limiting steps for nitrate reduction on atomically dispersed Fe sites.

The direct electrochemical synthesis of hydrogen peroxide is a promising alternative to currently used batch synthesis methods. Its industrial viability is dependent on the effective catalysis of the reduction of oxygen at the cathode. Herein, we study the factors controlling activity and selectivity for H2O2 production on metal surfaces. Using this approach, we discover two new catalysts for the reaction, Ag-Hg and Pd-Hg, with unique electrocatalytic properties both of which exhibit performance that far exceeds the current state-of-the art.

Precise control of elemental configurations within multimetallic nanoparticles (NPs) could enable access to functional nanomaterials with significant performance benefits. This can be achieved down to the atomic level by the disorder-to-order transformation of individual NPs. Here, by systematically controlling the ordering degree, we show that the atomic ordering transformation, applied to AuCu NPs, activates them to perform as selective electrocatalysts for CO2 reduction. In contrast to the disordered alloy NP, which is catalytically active for hydrogen evolution, ordered AuCu NPs selectively converted CO2 to CO at faradaic efficiency reaching 80%. CO formation could be achieved with a reduction in overpotential of ∼200 mV, and catalytic turnover was enhanced by 3.2-fold. In comparison to those obtained with a pure gold catalyst, mass activities could be improved as well. Atomic-level structural investigations revealed three atomic gold layers over the intermetallic core to be sufficient for enhanced catalytic behavior, which is further supported by DFT analysis.

Abstract The one-step electrochemical synthesis of H 2 O 2 is an on-site method that reduces dependence on the energy-intensive anthraquinone process. Oxidized carbon materials have proven to be promising catalysts due to their low cost and facile synthetic procedures. However, the nature of the active sites is still controversial, and direct experimental evidence is presently lacking. Here, we activate a carbon material with dangling edge sites and then decorate them with targeted functional groups. We show that quinone-enriched samples exhibit high selectivity and activity with a H 2 O 2 yield ratio of up to 97.8 % at 0.75 V vs. RHE. Using density functional theory calculations, we identify the activity trends of different possible quinone functional groups in the edge and basal plane of the carbon nanostructure and determine the most active motif. Our findings provide guidelines for designing carbon-based catalysts, which have simultaneous high selectivity and activity for H 2 O 2 synthesis.