Xiangyu Tang

PURPOSE: To determine the utility of intravoxel incoherent motion (IVIM) imaging in grading gliomas and compare IVIM perfusion metrics with arterial spin labeling (ASL)-derived cerebral blood flow (CBF). MATERIALS AND METHODS: Fifty-two patients with pathologically confirmed gliomas underwent IVIM and ASL imaging at 3.0T. IVIM perfusion-related diffusivity (D*), perfusion fraction (f), product of f and D*(f×D*), true diffusivity (D), and apparent diffusion coefficient (ADC) were obtained to distinguish glioma grades. The CBF derived from pseudocontinuous ASL within the solid tumor was compared and correlated with IVIM perfusion metrics for grading of gliomas. Values were also normalized to the contralateral normal-appearing white matter. Receiver-operating characteristic was performed to determine diagnostic efficiency. The reliability was estimated with intraclass coefficient, coefficient of variance, and Bland-Altman plots. RESULTS: IVIM perfusion metrics and CBF were significantly higher in the high-grade than the low-grade gliomas (P < 0.001), ADC and D were significantly lower in the high-grade than the low-grade gliomas (P < 0.001). f×D* differed significantly between grades II through IV (P < 0.05 for all). The other metrics showed significant difference between grade II and grade III (P < 0.05 for all). Area under the curve (AUC) was largest for f×D* in distinguishing high-grade from low-grade gliomas (AUC = 0.979, P < 0.001) and between grade II and grade III (AUC = 0.957, P < 0.001). f×D* improved diagnostic performance of CBF in grading gliomas and showed strong correlation with CBF (r = 0.696, P < 0.001). CONCLUSION: IVIM-derived metrics are promising biomarkers in preoperative grading gliomas. IVIM imaging may be an additive method to ASL and ADC for evaluating tumor perfusion and diffusion. J. Magn. Reson. Imaging 2016;44:620-632.

Purpose The aim of this study was to design and fabricate a three-dimensional (3D) printed artificial ovary.Methods We first compared the printability of gelatin-methacryloyl (GelMA), alginate and GelMA–alginate bioinks, of which GelMA was selected for further investigation. The swelling properties, degradation kinetics and shape fidelity of GelMA scaffolds were characterized by equilibrium swelling/lyophilization, collagenase processing and micro-computed tomography evaluation. Commercial ovarian tumor cell lines (COV434, KGN, ID8) and primary culture ovarian somatic cells were utilized to perform cell-laden 3D printing, and the results were evaluated by live/dead assays and TUNEL detection. Murine ovarian follicles were seeded in the ovarian scaffold and their diameters were recorded every day. Finally, in vitro maturation was performed, and the ovulated oocytes were collected and observed.Results Our results indicated that GelMA was suitable for 3D printing fabrication. Its scaffolds performed well in terms of hygroscopicity, degradation kinetics and shape fidelity. The viability of ovarian somatic cells was lower than that of commercial cell lines, suggesting that extrusion-based 3D culture fabrication is not suitable for primary ovarian cells. Nevertheless, the GelMA-based 3D printing system provided an appropriate microenvironment for ovarian follicles, which successfully grew and ovulated in the scaffolds. Metaphase II oocytes were also observed after in vitro maturation.Conclusions The GelMA-based 3D printing culture system is a viable alternative option for follicular growth, development and transfer. Accordingly, it shows promise for clinical application in the treatment of female endocrine and reproductive conditions.