Zhiyi Zhang

A hydrothermal approach for the cutting of boron-doped graphene (BG) into boron-doped graphene quantum dots (BGQDs) has been proposed. Various characterizations reveal that the boron atoms have been successfully doped into graphene structures with the atomic percentage of 3.45%. The generation of boronic acid groups on the BGQDs surfaces facilitates their application as a new photoluminescence (PL) probe for label free glucose sensing. It is postulated that the reaction of the two cis-diol units in glucose with the two boronic acid groups on the BGQDs surfaces creates structurally rigid BGQDs-glucose aggregates, restricting the intramolecular rotations and thus resulting in a great boost in the PL intensity. The present unusual "aggregation-induced PL increasing" sensing process excludes any saccharide with only one cis-diol unit, as manifested by the high specificity of BGQDs for glucose over its close isomeric cousins fructose, galactose, and mannose. It is believed that the doping of boron can introduce the GQDs to a new kind of surface state and offer great scientific insights to the PL enhancement mechanism with treatment of glucose.

The membrane disruption properties of high generation (G4 to G7) poly(amidoamine) (PAMAM) dendrimers are evaluated and compared to linear poly(lysine). The G6 and G7 dendrimers are unusually effective at inducing leaky fusion of anionic, large unilamellar vesicles, as determined by standard fluorescence assays for lipid mixing, leakage, and contents mixing. Both G7 dendrimer and poly(lysine) are able to disrupt sterically stabilized vesicles that are coated with poly(ethylene glycol). A G7 dendrimer/DNA complex with a 1:1 concentration ratio of dendrimer surface amines to DNA phosphate groups is unable to induce leakage of 3:7 POPA-PE vesicles; however, extensive leakage is observed when the surface amine to phosphate stoichiometry is >/=3:1. Thus, the DNA/dendrimer complexes that typically induce high levels of cell transfection are also able to induce high levels of vesicle leakage. The G7 dendrimer does not induce membrane phase separation in 3:7 POPA-PE vesicles, but an inverse hexagonal phase is observed by (31)P NMR. The enhanced membrane disruption is interpreted in terms of a membrane bending model. A rigid, polycationic dendrimer sphere uses electrostatic forces to bend a malleable, anionic membrane and induce bilayer packing stresses. This bending model is biomimetic in the sense that protein-induced membrane bending is currently thought to be an important factor in the fusion mechanism of influenza virus.

The graphene nanosheets-based epoxy resin coating (0, 0.1, 0.4 and 0.7 wt %) was prepared by a situ-synthesis method. The effect of polyvinylpyrrolidone/reduced graphene oxide (PVP-rGO) on mechanical and thermal properties of epoxy resin coating was investigated using nanoindentation technique and thermogravimetric analysis, respectively. A significant enhancement (ca. 213% and 73 °C) in the Young modulus and thermal stability of epoxy resin coating was obtained at a loading of 0.7 wt %, respectively. Furthermore, the erosion resistance of graphene nanosheets-based epoxy resin coating was investigated by electrochemical measurement. The results showed also that the Rrcco (ca. 0.3 mm/year) of graphene nanosheets-based epoxy resin coating was far lower than neat epoxy resin (1.3 mm/year). Thus, this approach provides a novel route for improving erosion resistance and mechanical-thermal stability of polymers coating, which is expected to be used in mechanical-thermal-corrosion coupling environments.

A high-pressure differential scanning calorimetric technique is described for studying polymer plasticization by compressed gases at pressures to 100 atm. The in situ measurements avoid problems due to gas desorption encountered with conventional DSCs, thus providing an accurate way to determine the change in glass transition temperature, Tg, with pressure, p. The entire Tg–p curve can be established in less than 2 days. The glass transition was observed as a sharp step in the case of 100–200-μm thin samples, whereas thicker samples gave a broad transition; highly reproducible results were obtained for the thin samples. For PS–CO2, the measured Tgs under various pressures were found to be in good agreement with literature values. Results for the systems PS–HFC134a, PVC–CO2, and PC–CO2 are also reported. © 1998 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys 36: 977–982, 1998