Ziang Wu

Abstract Recent advances in nonfullerene acceptors (NFAs) have enabled the rapid increase in power conversion efficiencies (PCEs) of organic photovoltaic (OPV) cells. However, this progress is achieved using highly toxic solvents, which are not suitable for the scalable large‐area processing method, becoming one of the biggest factors hindering the mass production and commercial applications of OPVs. Therefore, it is of great importance to get good eco‐compatible processability when designing efficient OPV materials. Here, to achieve high efficiency and good processability of the NFAs in eco‐compatible solvents, the flexible alkyl chains of the highly efficient NFA BTP‐4F‐8 (also known as Y6) are modified and BTP‐4F‐12 is synthesized. Combining with the polymer donor PBDB‐TF, BTP‐4F‐12 shows the best PCE of 16.4%. Importantly, when the polymer donor PBDB‐TF is replaced by T1 with better solubility, various eco‐compatible solvents can be applied to fabricate OPV cells. Finally, over 14% efficiency is obtained with tetrahydrofuran (THF) as the processing solvent for 1.07 cm 2 OPV cells by the blade‐coating method. These results indicate that the simple modification of the side chain can be used to tune the processability of active layer materials and thus make it more applicable for the mass production with environmentally benign solvents.

A direct regeneration of cathode materials from spent LiFePO₄ batteries using a solid phase sintering method has been proposed in this article.

Despite the significant progresses made in all-polymer solar cells (all-PSCs) recently, the relatively low short-circuit current density (Jsc) and large energy loss are still quite difficult to overcome for further development. To address these challenges, we developed a new class of narrow-bandgap polymer acceptors incorporating a benzotriazole (BTz)-core fused-ring segment, named the PZT series. Compared to the commonly used benzothiadiazole (BT)-containing polymer PYT, the less electron-deficient BTz renders PZT derivatives with significantly red-shifted optical absorption and up-shifted energy levels, leading to simultaneously improved Jsc and open-circuit voltage in the resultant all-PSCs. More importantly, a regioregular PZT (PZT-γ) has been developed to achieve higher regiospecificity for avoiding the formation of isomers during polymerization. Benefiting from the more extended absorption, better backbone ordering, and more optimal blend morphology with donor component, PZT-γ-based all-PSCs exhibit a record-high power conversion efficiency of 15.8% with a greatly enhanced Jsc of 24.7 mA/cm2 and a low energy loss of 0.51 eV.

Abstract Conducting polymers, such as the p -doped poly(3,4-ethylenedioxythiophene):poly(styrene sulfonate) (PEDOT:PSS), have enabled the development of an array of opto- and bio-electronics devices. However, to make these technologies truly pervasive, stable and easily processable, n -doped conducting polymers are also needed. Despite major efforts, no n -type equivalents to the benchmark PEDOT:PSS exist to date. Here, we report on the development of poly(benzimidazobenzophenanthroline):poly(ethyleneimine) (BBL:PEI) as an ethanol-based n -type conductive ink. BBL:PEI thin films yield an n -type electrical conductivity reaching 8 S cm −1 , along with excellent thermal, ambient, and solvent stability. This printable n -type mixed ion-electron conductor has several technological implications for realizing high-performance organic electronic devices, as demonstrated for organic thermoelectric generators with record high power output and n -type organic electrochemical transistors with a unique depletion mode of operation. BBL:PEI inks hold promise for the development of next-generation bioelectronics and wearable devices, in particular targeting novel functionality, efficiency, and power performance.