Roland Ryf

We report simultaneous transmission of six spatial and polarization modes, each carrying 40 Gb/s quadrature-phase-shift-keyed channels over 96 km of a low-differential group delay few-mode fiber. The channels are successfully recovered by offline DSP based on coherent detection and multiple-input multiple-output processing. A penalty of <formula formulatype="inline" xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"><tex Notation="TeX">${&lt;}1.2$</tex> </formula> dB is achieved by using 6 <formula formulatype="inline" xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"><tex Notation="TeX">$\,\times\,$</tex> </formula> 6 feed-forward equalizers with 120 taps each. The 6 <formula formulatype="inline" xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex Notation="TeX">$\,\times\,$</tex></formula> 6 impulse-response matrix fully characterizing the few-mode fiber is presented, revealing the coupling characteristics between the modes. The results are obtained using mode multiplexers based on phase plates with a mode selectivity of <formula formulatype="inline" xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex Notation="TeX">${&gt;}28$</tex></formula> dB.

Exploiting a particular wave property for a particular application necessitates components capable of discriminating in the basis of that property. While spectral or polarisation decomposition can be straightforward, spatial decomposition is inherently more difficult and few options exist regardless of wave type. Fourier decomposition by a lens is a rare simple example of a spatial decomposition of great practical importance and practical simplicity; a two-dimensional decomposition of a beam into its linear momentum components. Yet this is often not the most appropriate spatial basis. Previously, no device existed capable of a two-dimensional decomposition into orbital angular momentum components, or indeed any discrete basis, despite it being a fundamental property in many wave phenomena. We demonstrate an optical device capable of decomposing a beam into a Cartesian grid of identical Gaussian spots each containing a single Laguerre-Gaussian component, using just a spatial light modulator and mirror.

Mode-division multiplexing over 33-km few-mode fiber is investigated. It is shown that 6×6 MIMO processing can be used to almost completely compensate for crosstalk and intersymbol interference due to mode coupling in a system that transmits uncorrelated 28-GBaud QPSK signals on the six spatial and polarization modes supported by a novel few-mode fiber.

We demonstrate a 3x1 fiber-based photonic lantern spatial-multiplexer with mode-selectivity greater than 6 dB and transmission loss of less than 0.3 dB. The total insertion loss of the mode-selective multiplexers when coupled to a graded-index few-mode fiber was < 2 dB. These mode multiplexers showed mode-dependent loss below 0.5 dB. To our knowledge these are the lowest insertion and mode-dependent loss devices, which are also fully compatible with conventional few-mode fiber technology and broadband operation.

Optical fibers have often been considered to offer effectively infinite capacity to support the rapid traffic growth essential to our information society. However, as demand has grown and technology has developed, we have begun to realize that there is a fundamental limit to fiber capacity of ~ 100 Tb/s per fiber for systems based on conventional single-core single-mode optical fiber as the transmission medium. This limit arises from the interplay of a number of factors including the Shannon limit, optical fiber nonlinearities, the fiber fuse effect, as well as optical amplifier bandwidth. This article reviews the most recent research efforts around the globe launched over the past few years with a view to overcome these limitations and substantially increase capacity by exploring the last degree of freedom available: the spatial domain. Central to this effort has been the development of brand new fibers for space-division multiplexing and mode-division multiplexing.